GPRS

Packet switching is a digital networking communications method that groups all transmitted data, irrespective of content, type, or structure, into suitably sized blocks, called packets. Packet switching features delivery of variable bit rate data streams (sequences of packets) over a shared network. When traversing network adapters, switches, routers and other network nodes, packets are buffered and queued, resulting in variable delay and throughput depending on the traffic load in the network.

A mobile phone is an electronic device used for mobile telecommunications over a cellular network of base stations known as cell sites. Mobile phones differ from cordless telephones, which only offer telephone service within limited range through a single base station attached to a fixed line, for example within a home or an office. Low-end mobile phones are often referred to as feature phones, whereas high-end mobile phones that offer more advanced computing ability are referred to as smartphones.

GSM (Global System for Mobile Communications) is the most popular standard for mobile telephony systems in the world. The GSM Association, its promoting industry trade organization of mobile phone carriers and manufacturers, estimates that 80% of the global mobile market uses the standard. GSM is used by over 3 billion people across more than 212 countries and territories

Time division multiple access (TDMA) is a channel access method for shared medium networks. It allows several users to share the same frequency channel by dividing the signal into different time slots. The users transmit in rapid succession, one after the other, each using his own time slot. This allows multiple stations to share the same transmission medium (e.g. radio frequency channel) while using only a part of its channel capacity

Cellular Digital Packet Data (CDPD) was a wide-area mobile data service which used unused bandwidth normally used by AMPS mobile phones between 800 and 900 MHz to transfer data. Speeds up to 19.2 kbit/s were possible. The service was discontinued in conjunction with the retirement of the parent AMPS service; it has been functionally replaced by faster services such as 1xRTT, EV-DO, and UMTS/HSPA.

NTT DoCoMos i-mode is a mobile internet (as opposed to wireless internet) service popular in Japan. Unlike Wireless Application Protocol or WAP, i-mode encompasses a wider variety of internet standards, including web access, email and the packet switched network that delivers the data. i-mode users have access to various services such as email, sports results, weather forecast, games, financial services and ticket booking. Content is provided by specialized services, typically from the mobile carrier, which allows them to have tighter control over billing.

Dual Transfer Mode (DTM) is a protocol based on the GSM standard that allows simultaneous transfer of Circuit switched (CS) voice and Packet switched (PS) data over the same radio channel (ARFCN). DTM is a 3GPP baseline R99 feature.

Access point name (APN) identifies an IP packet data network (PDN), that a mobile data user wants to communicate with. In addition to identifying a PDN, an APN may also be used to define the type of service, (eg connection to wireless application protocol (WAP) server, multimedia messaging service (MMS)), that is provided by the PDN. APN is used in 3GPP data access networks, eg general packet radio service (GPRS), evolved packet core (EPC).

The General Packet Radio Service (GPRS) system is used by GSM mobile phones, the most common mobile phone system in the world, for transmitting IP packets. The GPRS core network is the centralized part of the GPRS system. It also provides support for WCDMA based 3G networks. The GPRS core network is an integrated part of the GSM network switching subsystem.

A base transceiver station (BTS) or cell site is a piece of equipment that facilitates wireless communication between user equipment (UE) and a network. UEs are devices like mobile phones (handsets), WLL phones, computers with wireless internet connectivity, WiFi and WiMAX gadgets etc. The network can be that of any of the wireless communication technologies like GSM, CDMA, WLL, WAN, WiFi, WiMAX etc. BTS is also referred to as the radio base station (RBS), node B (in 3G Networks) or, simply, the base station (BS). For discussion of the LTE standard the abbreviation eNB for enhanced node B is widely used.

☆ GPRS uses 2.5 generation of GSM signals

☆ The radio interface is the same that of GSM

☆ GPRS uses 900 / 1800 Mhz, frequency band and GMSK modulation

☆ The bit rates are EGPRS, similar to EDGE

☆ Separate hardware and ports need to be added and availed.

☆ Multiple access scheme is used in GPRS based on the FDD and TDMA

☆ One pair of up-link and down-link frequency channels are assigned to a user during a session

☆ The Multiple Access Coding Scheme is combined with statistical multiplexing [packet mode communication], that allows several uses to share the same frequency channel

☆ Down-link uses first-come first-served packet scheduling and up-link uses a scheme that is similar to reservation ALOHA.

☆ Slotted ALOHA is utilized for reservation inquiries in a contention phase, followed by transferring data by utilizing dynamic TDMA with first-come, first-served scheduling

☆ Speed of data transfer available in the Uplink and Downlink directions is determined by Multislot Class.

☆ The speed varies between 1 and 45 for allocating by the network to allocate radio channels in the uplink and downlink channels.

☆ The representation of multi slot class is 5+2, for example, where the first number is the number of down link time slots and the second number is the number of up link time slots that are allocated to use by a mobile station.

☆ GPRS provide gross data rate of 22.80 KBPS / time slot

☆ Voice uses only 13 KBPS/ time slot and the rest is consumed by Error Correction Code

☆ Error connection code is utilized for detecting and correcting the transmission errors

☆ As voice is compressed, the usage of Error connection code is mandatory

GPRS uses 2.5 generation of GSM signals

The radio interface is the same that of GSM.

GSM:

☆ Uses one among 7 slots

☆ Connecting resources to each unit from remote location to the back office is done through a direct dial up

☆ Circuit switched mode of operations

☆ Dedicated channel all the way to the destination is provided to the customer

GPRS:

☆ Uses as many as 4+1 time slots

☆ Does not claim any resources until some data is sent. The information is divided into packets

☆ Packet switched mode of operations

☆ One or more dedicated channels are assigned by the operator specifically for shared use