Safety Teacher

A safety audit is a workplace screening process that indicates any unsafe working conditions and recommends corrective measures. Is operates on measurements, analysis and testing.

One without the other is not potent enough for many situations so I would consider both very important. Training is a prerequisite and experience is comes with time. They cannot be compared or used interchangeably.

Any company has a social and legal obligation to provide a safe and health working environment to all his improvement to all his employees.

Any work above 2 meters from ground is caused work at height.

The process of lifting, carrying and stacking materials by men is called manual handing.

☛ He has to instruct this workers about the work methods and procedures.

☛ He has to maintain discipline among the workers

☛ He has to supply necessary materials

☛ He has to control quality and cost of the job

☛ He has to guide has workers in doing a job in the correct and safe way

☛ He has to supply suitable personal protective equipment to his workers

☛ He should conduct periodical safety meetings.

☛ He should conduct safety inspection of his working area

☛ He should know about the fire fight equipments

☛ He should know investigate the accident and find out the cause of accident

The process of joining of metals either by electrical or by gas is called welding.

Attitude may be described as continuous behavior . if man’s behavior is good, then his action will be either correct or safe.

It is an event which represents deviation from the intended sequence of designed steps.

There was this situation in which the university that I was working for fell under a vandalism attack. All security personnel looked for the perpetrator for three months but I was the one who managed to pinpoint a student responsible for the vile acts. It was unfortunate that the student was the son of my best friend. I had no option but to hand him in even though I knew I could very well let him go with a warning and none would be the wiser! My ethics said otherwise.

During an oil drilling project the drillers were using PPE but the audit revealed they were not using proper eye gear. I designed and recommended sealed eye gear for them and insisted on its use which paid off because the drillers came across a pungent gas during drilling which could have damaged their eyes causing serious threats on site and long term health issues had they not worn that equipment.

Safety is defined as a condition that is free from hazards while risk is the realization of a potential loss or injury.

I would say paying extra attention to details might be my weakness. I am highly cautious and do not sit back until I have thoroughly understood and figured out strategies to carry out things which sometimes over burdens me but in a way helps me perform better as a security officer.

Inherent property of a substance or an occurrence which has potential to cause loss or damage property, person or environment.

Marking a hole or tunnel by digging the ground by man or machine is called excavation.

Grinder is a portable machine with a wheel guard in position to reduced the danger.

Safety programme can be defined as five methods by which accident can be prevent easily they are engineering, education, enforcement, enthusiasm and example safety programmes are plain spoken and carry out certain legal steps.

Work permit system is a “ written documents” for permission to undertake a job by area in charge or it is written document issued by the area in charge to the performer to under take the specific job.

It is an equipments used to project the person from hazards such dust, dirt, fumes and sparks etc. It is the barrier between hazard and person.