Explain Which Two Of These Represent A Best Practice Implementation Of A Split MAC LWAPP Deployment In A CiscoUnified Wireless Network? (Choose Two.)A. Each Wireless Client Authentication Type Maps To A Shared SSID Which In Turn Maps To A Common SharedVLAN.B. Each Wireless Client Authentication Type Maps To A Unique SSID Which In Turn Maps To A Unique VLAN.C. Each Wireless Client Authentication Type Maps To A Unique SSID Which In Turn Maps To A Common SharedVLAN.D. 802.1Q Trunking Extends From The Wired Infrastructure To The Access Point For Translation Into SSID(s).E. 802.1Q Trunking Extends From The Wired Infrastructure To A Wireless LAN Controller For Translation IntoSSID(s).F. 802.1Q Trunking Extends From The Wired Infrastructure To A Wireless LAN Controller. Then The 802.1Q Packet Isencapsulated In LWAPP And Sent To The Access Point For Transmission Over The SSID(s).

⟩ Explain Which two of these represent a best practice implementation of a Split MAC LWAPP deployment in a CiscoUnified Wireless Network? (Choose two.)A. Each wireless client authentication type maps to a shared SSID which in turn maps to a common sharedVLAN.B. Each wireless client authentication type maps to a unique SSID which in turn maps to a unique VLAN.C. Each wireless client authentication type maps to a unique SSID which in turn maps to a common sharedVLAN.D. 802.1Q trunking extends from the wired infrastructure to the access point for translation into SSID(s).E. 802.1Q trunking extends from the wired infrastructure to a wireless LAN controller for translation intoSSID(s).F. 802.1Q trunking extends from the wired infrastructure to a wireless LAN controller. Then the 802.1Q packet isencapsulated in LWAPP and sent to the access point for transmission over the SSID(s).

B,E:Each wireless client authentication type maps to a unique SSID which in turn maps to a unique VLAN./802.1Q trunking extends from the wired infrastructure to a wireless LAN controller for translation into

SSID(s).

Is this answer helpful?
0 Yes | 0 No

264 views

Explain What best describes the following configuration example of allowas-in? router bgp 100address-family ipv4 vrf CustomerAneighbor 195.12.4.5 remote-as 123 neighbor 195.12.4.5activateneighbor 195.12.4.5 allowas-in 2A.permits incoming BGP updates defined by access-list 2B.permits incoming BGP updates defined by class-map 2C.permit incoming BGP updates defined by route-map 2D.permits incoming BGP updates with no more than two occurrences of AS 100 in the AS pathE.permits incoming BGP updates with no more than two occurrences of AS 123 in the AS path

Explain Which three statements are correct regarding Layer 2 overlay VPNs and peer-to-peer VPNs?A.Peer-to-peer VPNs require the establishment of virtual circuits to connect the different customer sitestogether.B.Peer-to-peer VPNs require the service provider to participate in the customer routing, acceptingcustomer routes, transporting them across the service provider backbone, and finally propagating them toother customer sites.C.With peer-to-peer VPNs, the service provider is responsible for transport of Layer 2 frames betweencustomer sites, and the customer takes responsibility for all higher layers.D.The implementation of Layer 2 overlay VPNs is the traditional switched-WAN model, implemented withtechnologies like X.25, Frame Relay or ATM.E.With Layer 2 overlay VPNs, the service provider is not aware of customer routing and has noinformation about customer routes.F.It is simple to implement Layer 2 overlay VPNs because the Customer Edge (CE) router just needs aconnection to the Ser

Which three components comprise a Cisco NAC Appliance solution? (Choose three.)A. a NAC-enabled Cisco routerB. a Linux server for in-band or out-of-band network admission controlC. a Linux server for centralized management of network admission serversD. a Cisco router to provide VPN servicesE. a read-only client operating on an endpoint deviceF. a NAC-enabled Cisco switch

When configuring the Cisco NAM to implement Cisco NAA requirementchecking on client machines, what is the next step after configuring checks and rules?A. retrieve updatesB. require the use of the Cisco NAAC. configure session timeout and traffic policiesD. map rules to requirementE. configure requirements

Explain What is a benefit of CEF switching?A.CEF supports IP source prefix-based switching using the FIB.B.CEF uses less memory than fast switching uses.C.CEF is less CPU intensive than fast switching is.D.CEF provides Netflow statistics with minimum CPU overhead.E.CEF allows multiple data planes to share a common control plane.

Explain What is a major drawback of using traditional IP routing over an ATM network when connectingmultiple sites?A.Each ATM switch in the path has to perform Layer 3 routing lookup.B.ATM virtual circuits have to be established between the different sites.C.There is high ATM management overhead between the ATM switch and the router at each site.D.Each ATM switch has to be manually configured to participate in Layer 3 routing.E.There is high PNNI overhead.

Explain Which description is NOT a topology where a central services VPN would be used?A.A service provider offers services to all customers by allowing them access to a commonVPN.B. Two or more companies want to exchange information by sharing a common set ofservers.C. A security-conscious company separates its departments and allows them to accessonly to common servers.D. Several interconnected subsidiaries of a company require optimal communicationbetween many sites.

Suppose A client has a network with wireless and wired users. The wired users runmission-critical bandwidth-sensitive applications. The wireless users access web-based support portalswithin the central office.Given only this information, which Cisco NAC Appliance solution would provide the most fault-tolerantoption for this client?A. one Cisco NAM and one in-band highly available Cisco NAS clusterB. one load-balanced highly available Cisco NAM cluster and one out-of-band highly available Cisco NASclusterC. one highly available Cisco NAM cluster, one out-of-band highly available Cisco NAS cluster, and onein-band Cisco NASD. one highly available Cisco NAM cluster and one in-band highly available Cisco NAS cluster

Suppose After you implement a network scan and view the report, you notice that aplug-in did not access any of its dependent plug-ins. What did you forget to do?A. enable the Dependent Plug-in check box on the General Tab formB. configure dependent plug-in support when you mapped the Nessus scan check to the Nessus plug-in ruleC. install dependent plug-ins when you updated the Cisco NAC Appliance plug-in libraryD. load the dependent plug-ins for that plug-in in the Plug-in Updates form

Explain Which three statements about MPLS VPNs are true? (Choose three.)A. PE routers do not participate in customer routing.B. MPLS VPN is similar to using the peer-to-peer dedicated PE router approach.C. Customer can use overlapping addresses.D. Each customer is assigned an independent routing table (virtual routing andforwarding table VRF).E. The P Routers routing table contains both the global IP routes and the customerroutes.F. CE routers connect directly to the service providers P routers.

Question and Answer:

Home CCDA Certification

Popular Answers:

* There is no answer to the above question yet.

More Questions for you:

Quick Links: