How To Make A Swap Partition Having 100MB. Make Automatically Usable At System Boot Time.

⟩ How to Make a swap partition having 100MB. Make Automatically Usable at System Boot Time.

1. Use fdisk /dev/hda ?To create new partition.

2. Type n ?For New partition

3. It will ask for Logical or Primary Partitions. Press l for logical.

4. It will ask for the Starting Cylinder: Use the Default by pressing Enter Key.

5. Type the Size: +100M ?You can Specify either Last cylinder of Size here.

6. Press P to verify the partitions lists and remember the partitions name.

Default System ID is 83 that means Linux Native.

7. Type t to change the System ID of partition.

8. Type Partition Number

9. Type 82 that means Linux Swap.

10. Press w to write on partitions table.

11. Either Reboot or use partprobe command.

12. mkswap /dev/hda? ?To create Swap File system on partition.

13. swapon /dev/hda? ?To enable the Swap space from partition.

14. free ?m ?Verify Either Swap is enabled or not.

15. vi /etc/fstab

/dev/hda? swap swap defaults 0 0

16. Reboot the System and verify that swap is automatically enabled or not.

Is this answer helpful?
0 Yes | 0 No

168 views

What is An incident logging system a only records defects b is of limited value c is a valuable source of project information during testing if it contains all incidents d. should be used only by the test team.

Explain Software testing activities should start a. as soon as the code is written b. during the design stage c. when the requirements have been formally documented d. as soon as possible in the development life cycle

Explain The later in the development life cycle a fault is discovered, the more expensive it is to fix. why? a. the documentation is poor, so it takes longer to find out what the software is doing. b. wages are rising c. the fault has been built into more documentation,code,tests, etc d. none of the above

Explain What is the main reason for testing software before releasing it? a. to show that system will work after release b. to decide when the software is of sufficient quality to release c. to find as many bugs as possible before release d. to give information for a risk based decision about release

Explain which of the following statements is not true a. performance testing can be done during unit testing as well as during the testing of whole system b. The acceptance test does not necessarily include a regression test c. Verification activities should not involve testers (reviews, inspections etc) d. Test environments should be as similar to production environments as possible

Suppose If the pseudocode below were a programming language ,how many tests are required to achieve 100% statement coverage? 1.If x=3 then 2. Display_messageX; 3. If y=2 then 4. Display_messageY; 5. Else 6. Display_messageZ; 7.Else 8. Display_messageZ; a. 1 b. 2 c. 3 d. 4

Question and Answer:

Home Red Hat Certification