⟩ Which interrupts are generally used for critical events?
Non-Maskable interrupts are used in critical events. Such as Power failure, Emergency, Shut off etc.
Question and Answer:
Home 8086
- Share
Popular Answers:
* There is no answer to the above question yet.
More Questions for you:
What command is used to reset a MODEM when using the A. ATR B. ATZ C. DTR D. DCE E. None of the above
Why does a successfully mapped network drive disappear every time you boot the computer? A. The computer you are connected to has moved B. You didn't click reconnect on log on C. The map statement is not in the autoexec.bat file D. The last drive was not set correctly E. None of the above
Modems use _____ transmission. A. Synchronous B. Asynchronous C. Timed interval D. PPP E. None of the above
You run a super wing-ding diagnostic program on your PC, and it reports that your hard drive, microprocessor, RAM, and video card have seen better days. To resolve this problem you should A. replace each part one at a time, rerunning the diagnostic before replacing the next part. B. check to see if you have a software problem C. replace everything at once and rerun the diagnostic D. get another copy of the diagnostic program E. run an exhaustive memory check
During the boot process, a system first counts memory from where? A. Expansion memory board B. Video adapter C. System board D. Cache E. None of the above
After you service a laser printer, you notice dirty print. Which of the following would correct the problem. A. Clean the developer tank B. Reset the printer C. Run several blank pages D. Clean the laser diode E. None of the above
What should he used to extinguish a computer fire? A. fire hose B. class a extinguisher C. class c extinguisher D. silver foam water E. None of the above
In ROM BIOS, the acronym BIOS stands for A. Basic Intuitive Output Set B. Basic Input Organizational System C. Basic Input Output System D. Basic Industry Operating System E. None of the above
Whenever you have a hardware resource conflict, it will more likely be an IRQ conflict rather than an i/o conflict because A. there are a lot more I/O addresses than IRQs. B. the BIOS sometimes has more of a problem controlling IRQs C. I/O addresses cannot conflict D. software tends to correct I/O conflicts E. software tends to mess up IRQs
You have just installed a new internal PCI modem on you desktop. It will not dial out. what is the problem? A. The port speed is set too high B. the modem has not been set up in control panel properties C. the phone line is plugged into the line-in port on the modem card D. the phone line out of the wall is plugged into the phone port on the modem card E. None of the above
