1.Enter into the BIOS and check whether your hard disk drive is set as first boot device,if not then set it as first boot device in the boot device priority.
2.If the problems exists,then you have to boot the system with a new operating system cd and install a new one.
3.Side by side check the RAM also for the connection
Design a state machine that produce 1 at its output z. when the specified 3 bit sequence appears at its input x unless the specified 3 bit seqence 2 occur this should then disable the out put until the circuit restarted. sequence1 001 and sequence 2 011?
Hardware Design interview questions part 1
Give two ways of converting a two input NAND gate to an inverter.
Give the truth table for a Half Adder. Give a gate level implementation of the same.
Design a divide-by-3 sequential circuit with 50% duty circle.
How do you detect a sequence of "1101" arriving serially from a signal line?
Suppose you have a combinational circuit between two registers driven by a clock. What will you do if the delay of the combinational circuit is greater than your clock signal?
Draw a Transmission Gate-based D-Latch?
Hardware Design interview questions part 2
Hardware Design interview questions part 3
rendc.org
Whether it is technological solutions or user-oriented innovations, We have put together for you the best sources of HR Interview Questions and Answers, Tech Ideas, and Programming Tutorials."
Get all the latest information on rendc.org
© 2022 | All rights reserved.
RENDC
welcome to www.rendc.org
