⟩ How to fix a DV6 with power problem. The problem of machine is it cannot power up at all?
Doing routine check:
1. system power: 3V, 5V all presented - ok
2. NBSWON signal: 3.3V presented - ok
3. press power button, NBSWON pull down to 0V, ok
4. check DNBSWON while press power button, no response. - problem.
in here I made a mistake, I didn't pay attention of the voltage of DNBSWON, this mistake waste me the next few days time. It should be 3.3V, but only about 1V.
Change EC as usual, because I thought the EC has problem. Then the big trouble comes - it auto power up once I plug in the power but stop in 0.04A current. Check and find no S5_ON signal, which indicate south bridge has problem, so change south bridge. But still same problem and still no S5_ON. I find that the EC I change is kb3926A rather than kb3926C. In most case, this is no problem but in very rare occation...
So I find a 3926C and put on. Now the motherboard is back to the same problem while I first start to check! So I change a wrong EC and this time I change a correct one, and also EC has no problem!
Because EC will start to read bios once the power plug in(not as people think, once you press power button). I check BIOS chip, BIOS_CS should have a countinue wave form but it just one stright line. BIOS chip is faulty, I replace the BIOS chip and it works perfect.
