⟩ Tell me in Autocad, what is the command that is used to rotate the grid at 45 degress?
To rotate the grid at 45 degrees, command UCS is used.
Question and Answer:
Home 3D Modeling
- Share
Popular Answers:
* There is no answer to the above question yet.
More Questions for you:
Teflon is used for bearings because of (a) Low co-efficient of friction (b) Better heat dissipation (c) Smaller space constraint (d) All of the above
Antifriction bearings are (a) Thick lubricated bearing (b) Thin lubricated bearing (c) Ball & roller bearing (d) Plastic bearing
A closed cycle gas turbine works on (a) Carnot cycle (b) Rankine cycle (c) Joule cycle (d) Atkinson cycle
Mass balancing is done to (a) Avoid flutter (b) Increase bending stress (c) Reduce drag (d) Distributing mass on control surface
Principle effect of humidity is (a) Corrosion (b) Leaking from sealed enclosures (c) Permanent set of packing and gaskets (d) Differential contraction of metal parts
Tell me what are the method of development?
What is position of views in First Angle Projection?
Mohr’s circle can be used to determine following stress on inclined surface (a) Principal stresses (b) Normal stresses (c) Maximum shear stresses (d) All of the above
Slow plastic deformation of material under constant stress is (a) Creep (b) Fatigue (c) Endurance (d) Elastic deformation
Tell us how can the reaction of support of a frame be evaluated?
