In talking with someone at Corel, I've learned that the content (clipart, fonts, photos) is not included on the DVD for CorelDRAW X7 and the only way to get it is to download individual pieces of content through Corel CONNECT. I find this news very disappointing and I'm guessing this will be an unpopular decision.
Slenderness ratio is the ratio of A. maximum size of column to minimum size of column B. width of column to depth of column C. effective length of column to least radius of gyration of the column D. effective length of column to width of column
In order to avoid tearing of the plate at an edge, the distance from the centre line of the rivet hole to the nearest edge of the plate should be equal to (where d = Diameter of rivet hole) A. d B. 1.5 d C. 2 d D. 2.5 d
According to Guest's theory, the failure occurs at a point in a member when the maximum shear stress in a bi-axial stress system reaches the shear stress at elastic limit in simple tension test. A. True B. False
In a flange coupling, the thickness of flanges is taken as one-half the diameter of shaft. A. Agree B. Disagree
The rolling contact bearings as compared to sliding contact bearings have A. small overall dimensions B. accuracy of shaft alignment C. low starting and low running friction except at very high speeds D. all of the above
The endurance limit for a mirror polished material will be __________ as compared to unpolished material. A. same B. less C. more
The maximum normal stress theory is used for A. brittle materials B. ductile materials C. plastic materials D. non-ferrous materials
The bearings of heavy series have capacity __________ over the medium series. A. 10 to 20% B. 20 to 30% C. 30 to 40% D. 40 to 50%
Two shafts A and B under pure torsion are of identical length and identical weight and are made of the same material. The shaft A is solid and the shaft B is hollow. We can say that A. shaft B is better than shaft A B. shaft A is better than shaft B C. both the shafts are equally good
Which of the following statement is correct for gears? A. The addendum is less than dedendum B. The pitch circle diameter is equal to the product of module and number of teeth C. The pitch circle is always greater than the base circle D. all of the above
rendc.org
Whether it is technological solutions or user-oriented innovations, We have put together for you the best sources of HR Interview Questions and Answers, Tech Ideas, and Programming Tutorials."
Get all the latest information on rendc.org
© 2022 | All rights reserved.
RENDC
welcome to www.rendc.org
