⟩ Which fill tool has been used to attain the result shown in the picture above? a Interactive Fill b Post Script Fill c Smart Fill d Mesh Fill
Please share your answers.
Question and Answer:
Home CorelDraw
- Share
Popular Answers:
* There is no answer to the above question yet.
More Questions for you:
In order to avoid tearing of the plate at an edge, the distance from the centre line of the rivet hole to the nearest edge of the plate should be equal to (where d = Diameter of rivet hole) A. d B. 1.5 d C. 2 d D. 2.5 d
According to Guest's theory, the failure occurs at a point in a member when the maximum shear stress in a bi-axial stress system reaches the shear stress at elastic limit in simple tension test. A. True B. False
In a flange coupling, the thickness of flanges is taken as one-half the diameter of shaft. A. Agree B. Disagree
The rolling contact bearings as compared to sliding contact bearings have A. small overall dimensions B. accuracy of shaft alignment C. low starting and low running friction except at very high speeds D. all of the above
The endurance limit for a mirror polished material will be __________ as compared to unpolished material. A. same B. less C. more
The maximum normal stress theory is used for A. brittle materials B. ductile materials C. plastic materials D. non-ferrous materials
The bearings of heavy series have capacity __________ over the medium series. A. 10 to 20% B. 20 to 30% C. 30 to 40% D. 40 to 50%
Two shafts A and B under pure torsion are of identical length and identical weight and are made of the same material. The shaft A is solid and the shaft B is hollow. We can say that A. shaft B is better than shaft A B. shaft A is better than shaft B C. both the shafts are equally good
Which of the following statement is correct for gears? A. The addendum is less than dedendum B. The pitch circle diameter is equal to the product of module and number of teeth C. The pitch circle is always greater than the base circle D. all of the above
The constant factor in case of R10 series of preferred numbers is A. 1.06 B. 1.12 C. 1.26 D. 1.58
