⟩ CorelDraw allows you to rotate the guidelines. a True b False
b: False
Question and Answer:
Home CorelDraw
- Share
Popular Answers:
* There is no answer to the above question yet.
More Questions for you:
The velocity of sliding __________ the distance of the point of contact from the pitch point. A. is directly proportional to B. is inversely proportional to C. is equal to cos φ multiplied by D. does not depend upon
A locking device in which the bottom cylindrical portion is recessed to receive the tip of the locking set screw, is called A. castle nut B. jam nut C. ring nut D. sawn nut
The application of third type levers is found in A. handle of a hand pump B. hand wheel of a punching press C. lever of a loaded safety valve D. a pair of tongs
A crankshaft is a __________ shaft. A. transmission B. machine
According to Indian standard specifications, 100 H6/g5 means that the A. actual size is 100 mm B. basic size is 100 mm C. difference between the actual size and basic size is 100 mm D. none of the above
When a bolt is subjected to shock loading, the resilience of the bolt should be considered in order to prevent breakage at the A. head B. shank C. thread D. middle
Stress concentration is caused due to A. variations in load acting on a member B. variations in properties of materials in a member C. abrupt change of cross-section D. all of these
In leaf springs, the longest leaf is known as A. lower leaf B. master leaf C. upper leaf D. none of these
Surface endurance limit of gear material is dependent upon its A. elastic strength B. yield strength C. brinell hardness number D. toughness
The toughness of a material __________ when it is heated. A. increases B. decreases C. does not change
