It's an acquired skill. To convert a miniature requires a lot of imagination, steady hands, patience, and a few out-of-the-ordinary tools. Costumes have to be obliterated, faces changed, weapons removed or added or changed. In all honesty, the processes involved are more numerous than can be addressed in this FAQ. Therefore, only the most common modifications will be addressed. Tools: To properly modify a miniature, you're going to need: files (round, triangular, square, flat), the smaller the better X-acto knife and several replacement blades glue, preferably Zap-A-Gap, possibly epoxy nail scissors or tiny wire cutters needle-nose pliers, the smaller the better sandpaper and/or emery boards a hacksaw, the finest you can get any new pieces you want to add (weapons, etc.) % The most common modification is to change one weapon for another. For purposes of explaination, a fantasy figure will be used, the change being from sword to battleaxe, assuming the sword had been molded as one with the hand. First, clip or cut the sword off on either side of the hand, being very careful not to damage the hand. The new piece may be one cut from another miniature, or one acquired from a weapons pack. If it is the latter, you will need to measure it against the hand and cut out part of the handle to compensate. The next step is to make holes in either side of the hand where the handle enters in order to insert the new parts. An X-acto blade or file may be used. A pin drill would come in handy about now. Once the holes are made, a drop of glue is placed in each one, then the handles are carefully set in place. The glue should show, as the extra is needed to keep the parts in place. Hold until set, possibly reinforce with a little tape, a brace, or some sort of clamping arrangement, and let set. After the glue is thorughly dry, a file or emery board can be used to clean up the excess, Avoid using a knife or razor blade, as you're likely to take off too much glue and the weapon will simply fall off again. % Another common modification is to make a miniature suitable for superhero use. The easiest way to do this is to file and sand the clothing smooth with the rest of the body, then paint on the costume of your choice.