61⟩ Which type of updates EIGRP protocol do?
INCREMENTAL UPDATES (CHANGE BASE)
CCNA
Home Networking CCNA
“Cisco Certified Network Administrators guide for getting job in Networking department. This guide will help you to get preparation of CCNA Interview.”
214 CCNA Questions And Answers
62⟩ What is the draw back of EIGRP protocol?
CONFIGURE ONLY ON CISCO ROUTERS
63⟩ What is the matric of EIGRP protocol?
i) Bandwidth
ii) Load
iii) Delay
iv) Reliability
v) MTU
vi) Maximum Transmission Unit
64⟩ In EIGRP metric parameters which 2 Options are enable by default?
i) Bandwidth
ii) Delay
65⟩ Which protocol can do load balancing on unequal cost also?
EIGRP
66⟩ 1350 value in which type of Access-list?
STANDARD ACCESS-LIST
67⟩ 1900 value in which type of Access list?
STANDARD ACCESS-LIST
68⟩ 2500 value in which type of Access list?
EXTENDED ACCESS-LIST
69⟩ What is the difference between named and Extended ACL?
In named Access-list we can edit and also give name
70⟩ When we use standard Access-List?
When there is no Destination
71⟩ When we use extended Access-List?
When there is source and Destination
72⟩ What is the default behavior of Access-List?
Deny
73⟩ On which interface we always Apply Access-List?
Fast Ethernet
74⟩ Wild card mask always in odd value or even?
ODD
75⟩ What is difference between Baseband and Broadband Transmission in ccna?
In a baseband transmission, the entire bandwidth of the cable is consumed by a single signal.
In broadband transmission, signals are sent on multiple frequencies, allowing multiple signals to be sent simultaneously.
76⟩ On which bas OSPF take decision?
LINK COST
77⟩ What is default cost of serial interface in OSPF?
64
78⟩ How many types of OSPF Configuration?
There are Two Types
A ) SINGLE AREA
b) MULTI AREA
79⟩ What is Protocol Data Unit in ccna?
The processes at each layer of the OSI model.
Layers----------PDU
Transport-------Segments
Network---------Packets/Datagrams
Data Link-------Frames
Physical--------Bits
80⟩ What is hold down time formula of OSPF?
HELLO PACKETS*4=40SECONDS
