⟩ How to enter from command mode to insertion mode using Vi Editor?
There are several commands that put the VI editor into
insert mode. The most commonly used commands to get into
insert mode are a and i.
Question and Answer:
Home Vi Editor
- Share
Popular Answers:
* There is no answer to the above question yet.
More Questions for you:
Give truth table for a Half Adder, Give a gate level implementation of the same?
What are different Adder circuits you studied?
Suppose you have a combinational circuit between two registers driven by a clock. What will you do if the delay of the combinational circuit is greater than your clock signal?
Explain Transmission Gate-based D-Latch?
Design a Transmission Gate based XOR. Now, how do you convert it to XNOR?
What is an anti aliasing filter and why is it required?
Explain Is the Gibbs phenomenon ever a factor?
Suppose we are sending address of thesalve and then data then after i want to read the data which i was sent recently, in that case before im reading is there any need to send a stop bit before read?
Can we create a table with out primary key?
Do you know How is the non-periodic nature of the input signal handled?
