* a) Must comply with BS 7671
* b) Are used to prove the circuit was dead only
* c) Are used to prove the circuit was alive only
* d) Are “proved” prior to and “re-proved” after isolation
Answer – d
Give here your suggestion about microprocessor 8085 and 8086. These 2 processors used in old time. I want to know its program execution time, memory space?
Tell me, when a sample of germanium and silicon having same impurity density are kept at room temperature then Resistivity of silicon will be higher than that of germanium, Why?
Why the antenna is called passive element?
Which of the following is is used to hold ROM and RAM cards1. Computer Bus 2. Expansion cards3. Mother Board 4. Cache memory
Why are the 2 input terminals of an op-amp are called as inverting & non-inverting terminals?
How the active power factor correction changes the wave shape of current drawn by a load to improve the power factor?
Explain what is meant by virtual ground in the op amp?
How many characters per sec (7 bits + 1 parity ) can be transmitted over a 2400 bps line if the transfer is synchronous (1 start and 1 stop bit)?1. 300 2. 2403. 250 4. 275
Explain what type of architecture is used in 8085 microprocessor?
What is a sequential circuit and What is a combinational circuit?Is there any difference between them? If yes what is it?
rendc.org
Whether it is technological solutions or user-oriented innovations, We have put together for you the best sources of HR Interview Questions and Answers, Tech Ideas, and Programming Tutorials."
Get all the latest information on rendc.org
© 2022 | All rights reserved.
RENDC
welcome to www.rendc.org
