⟩ Which of the following lamps would not normally form part of a highway electrical system?
* a) Low pressure mercury (T8-T12)
* b) Low pressure mercury (MBF)
* c) Metal halide (MBI)
* d) Incandescent Lamp (100W)
Answer – d
Question and Answer:
Home Electrical Engineering
- Share
Popular Answers:
* There is no answer to the above question yet.
More Questions for you:
Tell me, when a sample of germanium and silicon having same impurity density are kept at room temperature then Resistivity of silicon will be higher than that of germanium, Why?
Why the antenna is called passive element?
Which of the following is is used to hold ROM and RAM cards1. Computer Bus 2. Expansion cards3. Mother Board 4. Cache memory
Why are the 2 input terminals of an op-amp are called as inverting & non-inverting terminals?
How the active power factor correction changes the wave shape of current drawn by a load to improve the power factor?
Explain what is meant by virtual ground in the op amp?
How many characters per sec (7 bits + 1 parity ) can be transmitted over a 2400 bps line if the transfer is synchronous (1 start and 1 stop bit)?1. 300 2. 2403. 250 4. 275
Explain what type of architecture is used in 8085 microprocessor?
What is a sequential circuit and What is a combinational circuit?Is there any difference between them? If yes what is it?
74LS244 is _____?
