☛ Would you rather write a report or give it verbally?
☛ Your greatest weakness in school or at work?
☛ What do you believe are your key strengths?
☛ Tell us about the last time you had to negotiate with someone.
☛ Time when you made a suggestion to improve the work.
Grinding wheels should be tested for balance A. only at the time of manufacture B. before starting the grinding operation C. at the end of grinding operation D. occasionally
Larger end cutting edge angle __________ tool life. A. increases B. decreases C. does not effect
Which of the following statement is incorrect with reference of lathe cutting tools? A. The flank of the tool is the surface or surfaces below and adjacent to the cutting edges B. The nose is the corner, arc or chamfer joining the side cutting and the end cutting edges C. The heel is that part of the tool which is shaped to produce the cutting edges and face D. The base is that surface of the shank which bears against the support and takes tangent pressure of the cut
The cutting in a milling machine is mounted on.?
In hot machining, tool is made of A. tungsten carbide B. brass or copper C. diamond D. stainless steel
In ultra-sonic machining, the metal is removed by A. using abrasive slurry between the tool and work B. direct contact of tool with the work C. maintaining an electrolyte between the work and tool in a very small gap between the two D. erosion caused by rapidly recurring spark discharges between the tool and work
The angle included between the two lips projected upon a plane parallel to the drill axis and paralled to the two cutting lips, is called helix angle. A. Correct B. Incorrect
The correct sequence of tool materials in increasing order of their ability to retain their hot hardness is A. carbide, ceramic, cermet, borazon B. ceramic, carbide, borazon, cermet C. cermet, carbide, ceramic, borazon D. borazon, ceramic, carbide, cermet
The different spindle speeds on a lathe form A. arithmetical progression B. geometrical progression C. harmonical progression D. any one of these
In the relation VT(n) = C, the value of n for carbide tools is A. 0.1 to 0.2 B. 0.20 to 0.25 C. 0.25 to 0.40 D. 0.40 to 0.55
rendc.org
Whether it is technological solutions or user-oriented innovations, We have put together for you the best sources of HR Interview Questions and Answers, Tech Ideas, and Programming Tutorials."
Get all the latest information on rendc.org
© 2022 | All rights reserved.
RENDC
welcome to www.rendc.org
