⟩ When designing an integrated circuit measuring 5mm x 5mm the measurements should be entered using a scale of
(a) 1:1
(b) 1:2
(c) 1:10
(d) 1:5
(a) 1:1
(b) 1:2
(c) 1:10
(d) 1:5
Which one of the following key combinations will toggle COORDS?
Which one of the following key combinations will toggle SNAP?
Which of the following statements is true?
Which of the following key combinations issues the ISOPLANE command?
The shortcuts or command alias that allows us to key in L and AutoCAD responds with LINE are stored in a file named
The MAXIMUM number of commands whose effect can be undone by the UNDO command is?
Which one of the following commands would be used to limit the movement of the cursor to specified increments?
Which one of the following key combinations is a standard windoze short cut that does not relate to the clipboard.
Which one of the following commands can be used to turn the grid through 45 degrees ?
Which one of the following BEST defines a "prototype" or "template" drawing?