⟩ How to check NIS Users in a singal command?
From NIS client type the following command.
#ypcat -k passwd | grep userid
Question and Answer:
Home Solaris System Calls
- Share
Popular Answers:
* There is no answer to the above question yet.
More Questions for you:
Explain about stress analysis?
What is the testing done in aerospace engineering?
How would you handle if your co-worker were not co-operating with you?
What would you do if your Captain were not following the instructions properly?
When can one deviate from any flight rules and regulations?
What if you loose the medical round or interview for your pilot position?
Are you prepared for unexpected turbulence?
When a pilot is assigned a speed, how much can one deviate from that speed?
Without Air Traffic Control, what is the minimum descent rate you can descend the plane?
You are about to take off the plane in few seconds and a catastrophic engine fails, and your captain tells you not to take off and just stay in the center line. What would you do?
