Shoe Maker

A hole through which you lace up a shoe.

The fitting of the shoe is approved.

making or becoming suitable; adjusting

A non-woven reinforcement material that is impregnated with a chemical hardener that sets with application of heat or another chemical. Used commonly for heel counter reinforcement on really cheap shoes.

The Mustache is the shoe part attached to the shoe above the heel counter part. The classic sneaker will have a Mustache

The Egg crate pattern of square or diamond shape walls may fill the heel of a solid rubber boot sole. They save weight but allow for sturdy sole unit. Egg crate may also be used to replace foam inside the midsole of an inexpensive shoe. Egg crate may also be used to level the inside surface of a rubber outsole to allow sheet cut midsole to fit properly.

The cuff alignment allows the boot cuff to follow the line of the leg in the boot.

the lap consisting of a turned-back hem encircling the end of a material

A color dam on a shoe bottom is a raised ridge and/or groove in a mold to stop the flow of rubber. A sneaker shoe bottom will have color dams dividing all the colors on the sole.

A new cotton material was used to produce that special part of the shoe.

fabric woven from cotton fibres

The standard glue allowance is 2mm. The outsole glue may be applied up to 2mm above the outs top edge. This allows a good bond – but too much can turn yellow later and not looks good.

A color/material combination. A model of a shoe may have many colorways.

A shoe outsole type made of one piece of rubber. Called a cup sole as the sole unit “cups” the upper. Inside the cup can be EVA foam for rubber ribs egg crate pattern.

At the back or shoe shoe’s top line, above the heel counter the shoe may have a dip in the center. This is the heel notch.

The Shoe last is the foot form that is used to set the shape shoes. The shoe last can be made of plastic, Metal or wood.

This is the top, full grain layer of the hide, but the outer surface has been “brushed” away leaving a very soft nape suede like surface.

Insole Board A paper based board used to provide structure inside a shoe. For example, a stiff hiking boot will have a thick plastic lasting board. Also called Sockliner

Interlock loss is the material lost when a big pattern part is cut. For example a classic one piece hiking boot pattern can’t fit closely on the hide. The material in-between the parts is lost.

Footbed or Insole is the foam padded mesh that your foot stands on. May be removable or may be cemented in. High end shoes will be molded EVA of PU foam – Low end shoes will be die cut EVA.

The Master Carton or Case pack for Production shoes is usually a 10 or 12 pack depending on the size of the shoe and shoe inner box. In the master carton the Inner boxes will be arrange so the warehouse worker can see shoe box end labels for size and color information.

LOP is a critical part of the shoe factories price for a shoe. The factory will add up all the material costs then add the Labor Rate , Overhead and Profit required. The LOP for a shoe can be 30% of the total cost of a shoe. Just a few dollars for a simple skate shoe up to $10 or $15 for a snowboarding boot. Some factories will add a percentage on to the material cost to account for the LOP. Other factories carefully calculate each component.

When you negotiate a shoe price you need be clear on where the finished shoe is to be delivered. Ex-Works means the Price does not include any shipping . The buyer would be responsible for collecting the product from the factory.